2001 Arctic Cat ATVs factory service and repair manual, Page 196Get this manual
3Install the two starter gear shafts; then install the two starter gears (with the beveled side of each gear facing inward as noted in removing)Fig3-708
Fig3-710
! CAUTION
Make sure the speedometer gear and output shaft gear match up during assembly
4In order on the crankshaft, install washer, ring gear, rotorflywheel key, and the rotorflywheelSecure with the nut (threads coated with red Loctite #271)Tighten to 16 kg-m (116 ft-lb)5Lubricate the magneto cover gasket with fresh engine oil; then place it into position on the two dowel pinsFig3-709