2001 Arctic Cat ATVs factory service and repair manual, Page 194Get this manual
! CAUTION When installed correctly, the green alignment dot on the one-way clutch DOES NOT SHOW
Fig3-701
11Place the clutch coverclutch housing assembly into position on the crankcase; then secure with the cap screws making sure the different-lengthed cap screws are in their proper locationTighten to 1.1 kg-m (8 ft-lb)12Place the air intake plate cushion into position; then install the air intake plateTighten the Phillips-head screws (threads treated with small amount of red Loctite #271) securelyFig3-699
14Slide the fixed drive face onto the shaft15Spread the faces of the driven clutch by pushing the inner face toward the engine while turning it counterclockwise; then when the faces are separated, insert wedge (approximately 38 inthick) between the facesRelease the inner faceFig3-702