2001 Arctic Cat ATVs factory service and repair manual, Page 180Get this manual
+ Click Here Back NOTE: There is an oil passage beneath the driven geardrive gear assemblyThis passage should be plugged prior to removing the driven gear and drive gearFailure to do so could result in the loss of an alignment pin into the crankcase
Removing Right-Side Components
1Remove the cap screws securing the V-belt cover noting the location of the different-lengthed cap screws for installing purposes; then using rubber mallet, gently tap on the cover tabs to loosen the coverFig3-625
13Remove the snap ring securing the water pump drive gear; then remove the gear noting the direction of the sides of the gear for installing purposesAccount for the drive gear alignment pinFig3-624