2001 Arctic Cat ATVs factory service and repair manual, Page 179Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 179

8Using Side Case Puller (pn 0644-262), remove the side coverAccount for gasket and two alignment pinsFig3-618
+ AT THIS POINT
To service the magneto assembly, see Section 5
11Remove the two starter gears from the crankcase noting the direction of the beveled side of the gears for installing purposes; then remove the two starter gear shaftsFig3-621

9Remove the nut securing the rotorflywheel to the crankshaft; then install the magneto rotor puller adapterNOTE: The puller has left-hand threadsCC636

Back to 2001 Arctic Cat ATVs factory service and repair manual