2001 Arctic Cat ATVs factory service and repair manual, Page 157Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 157

29Place the gasket and recoil starter assembly into position on the left-side cover; then tighten four cap screws to 0.8 kg-m (6 ft-lb)Fig3-512
Fig3-514

ATV-1085

NOTE: To be installed correctly, the ends of the corrugated oil ring must touchCC039D

Installing Top-Side Components
APiston BCylinder
Fig3-513

! CAUTION
Install the middle and upper oil rings so the letter on the top surface of each ring faces the dome of the pistonFig3-515

Back to 2001 Arctic Cat ATVs factory service and repair manual