2001 Arctic Cat ATVs factory service and repair manual, Page 156Get this manual
+ Click Here Back Fig3-506
NOTE: Position the shift lever part way onto the splines and verify the subtransmission is in Hi rangeIf not, shift into Hi rangeFig3-509
25Place the speedometer drive adapter and gasket into position and secure with the two cap screwsTighten securely
! CAUTION
Make sure the speedometer gear and output shaft gear match up during assemblyFig3-507
27Pull up on the HiLow shift T-handle and guide the T-handle stop pin into the Hi range lever stop plate slot; then slide the shift lever assembly the rest of the way onto the shift shaftSecure with the outer circlip making sure the sharp side of the circlip faces away from the HiLow-range leverFig3-510