2001 Arctic Cat ATVs factory service and repair manual, Page 155Get this manual
Fig3-501
CStator AssemblyCover DSpeedometer Drive EHiLow Shifter Assembly FRecoil Starter NOTE: Steps 1-20 in the preceding sub-section must precede this procedure
21Place the gasket and left-side cover into position on the crankcaseNOTE: It may be necessary to push or pull the splined HiLow range shift shaft to establish covercrankcase matingCC332D
19Place the magneto rotor into position on the crankshaft; then install the magneto nut on the crankshaft and tighten until the rotor is properly seatedTighten to 16 kg-m (116 ft-lb)Fig3-502
22Install the fourteen cap screws to secure the left-side coverNote the location of the long cap screw with rubber gasketFig3-504