2001 Arctic Cat ATVs factory service and repair manual, Page 120Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 120

2Remove the flange nut securing the spacer to the crankshaft; then remove the spacerFig3-310
Fig3-312

CC512DA

BMagneto Rotor CIdle Gear Assembly NOTE: Steps 1-4 in the preceding sub-section must precede this procedure
3Lay the enginetransmission on its right side; then remove the fourteen cap screws securing the left-side cover to the crankcase and note the location of the long cap screw with rubber washerFig3-311

5Remove the nut securing the rotor to the crankshaft; then install the magneto rotor puller adapterFig3-313

Back to 2001 Arctic Cat ATVs factory service and repair manual