2001 Arctic Cat ATVs factory service and repair manual, Page 112Get this manual
3Drain the oil from beneath the enginetransmission; then drain the cooling systemFig3-270
Fig3-272
ATV-0109
4Drain the gas from the gas tank; then remove the tank (see Section 4)5Remove the front fenders and the front rack (see Section 8)6Remove the two cap screws securing the exhaust header pipe to the engine; then free the pipe from the engineAccount for grafoil gasket7Loosen the exhaust pipe from the muffler at the juncture in front of the muffler; then remove the exhaust pipeFig3-271
9Mark the reverse gear shaft arm to the reverse shift shaft to aid in assembly and remove the cap screw securing the reverse gear shaft arm to the reverse shift shaft; then route the cable and arm away from the enginetransmissionFig3-273