2001 Arctic Cat ATVs factory service and repair manual, Page 49Get this manual
NOTE: The brake pads should be replaced as setInstalling
2Press the foot brake pedal several times to check for firmnessFig2-103
1Place the brake pads into the caliperNOTE: The metal backing of the pad will be facing the adjuster arms when installed properly
2Slide brake caliper assembly over the brake disc and into position; then secure the caliper with the cap screws (coated with blue Loctite #243) tightened to 2.8 kg-m (20 ft-lb)3Install the wheel and secureTighten to 6.9 kg-m (50 ft-lb)4Adjust the brake (see Adjusting in this sub-section)5Remove the ATV from the support standNOTE: Whenever installing new pads, the new pads must be burnished (see Burnishing Brake Pads in this section)0735-507
3If the pedal is not firm, the system must be heldNOTE: To bleed the hydraulic foot brake system, use the basic procedure in Hydraulic Hand Brake System in this section
Hydraulic Foot Brake System
(Automatic Transmission)