2001 Arctic Cat ATVs factory service and repair manual, Page 47Get this manual
2Measure the thickness of each brake padFig2-95
AF615D AF739DB
EInstall the wheelTighten to 6.9 kg-m (50 ft-lb)
3If thickness of either brake pad is less than 3.2 mm (0.125 in, the brake pads must be replacedNOTE: The brake pads should be replaced as set
5Burnish the brake pads (see Burnishing Brake Pads in this section)
4To replace the brake pads, use the following procedureARemove the wheelBRemove the cap screws securing the caliper to the bracket; then remove the cotter pin securing the pads and remove the padsFig2-96
Mechanical Foot Brake
(Manual Transmission)