2001 Arctic Cat ATVs factory service and repair manual, Page 43Get this manual
If the reverse lever light does not illuminate when shifted to the reverse position, the switch may be faulty, the fuse may be blown, the bulb may be faulty, connection may be loose or corroded, or the lever may need adjustingTo adjust, use the following procedure1Shift the lever to the "forward" position2Disconnect the cable from the reverse shift arm by removing the clevis pinclip3At the adjuster, loosen the "upper" jam nut and thread it to the middle of the adjuster4Shift the lever to the "reverse" position5At the reverse shift arm, attempt to line the cable connector with the engine arm and install the clevis pinclip6If the clevis pinclip cannot be installed, adjust the "lower" jam nut until it can be installed7Tighten the "lower" jam nut and the "upper" jam nut to secure the adjustment NOTE: At this point the reverse lever should be adjusted correctlyIf the indicator light does not illuminate, troubleshoot the other possible reasonsFig2-86