2000 Arctic Cat ATV Factory Service Manual, Page 307Get this manual
CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary 2Measure the distance from the floor to the mid-point of each headlight3Using the measurements obtained in step 2, make horizontal marks on the aiming surface4Make vertical marks which intersect the horizontal marks on the aiming surface directly in front of the headlights5Switch on the lightsMake sure the HIGH beam is onDO NOT USE LOW BEAM6Observe each headlight beam aimProper aim is when the most intense beam is centered on the vertical mark cm (2 in below the horizontal mark on the aiming surfaceFig8-79
1C ea ll re ar fender components with parts-cleaning solvent and soap and water2Inspect side panels, fender extensions, and rear fenders for cracks and loose rivets3Inspect threaded areas of all mounting bosses for stripping4Inspect for missing decalsINSTALLING