2000 Arctic Cat ATV Factory Service Manual, Page 294Get this manual
3Wipe off any excess glue; then secure the grip with new rivet4Install the plug on the head of the rivet 5Remove the hub assembly6Remove the cotter pin from the tie rod end and remove the tie rod end from the knuckle7Remove the two cap screws securing the ball joints in the knuckle8Tap the ball joint end out of the knuckle; then remove the knuckle9Remove the seal from the knuckleFig8-22
KnucklesSpindles
REMOVING AND DISASSEMBLING
1Secure the ATV on support stand to elevate the wheel; then remove the wheel