2000 Arctic Cat ATV Factory Service Manual, Page 222Get this manual
RESISTANCE (HI Beam)
1Set the meter selector to the OHMS position2Connect the red tester lead to the yellow wire; connect the black tester lead to the gray wire3With the dimmer switch in the HI position, the meter must show less than ohmNOTE: If the meter shows more than ohm of istancetroubleshoot or replace the switchcomponent, the connector, or the switch wiring harnessRESISTANCE (LO Beam)
NOTE: If the meter shows more than ohm of istanceroubleshoot or replace the switchcomponent, the connector, or the switch wiring harness
Magneto Assembly
VOLTAGE (Charging CoilsOutput)
1Set the meter selector to the D.CVoltage position2Connect the red tester lead to the positive battery post; connect the black tester lead to the negative battery post3With the engine running at constant 5000 RPM (with the headlights on), the meter must show 14-15.5 D.Cvolts