2000 Arctic Cat ATV Factory Service Manual, Page 220Get this manual
1Remove the three machine screws and key cover securing the instrument pod2Remove the light bar from the instrument pod; then cut the cable tie securing the instrument pod wiring to the steering post3Push the instrument pod wiring with light bar downward to access the indicator light connector; then disconnect the connector from the main wiring harnessNOTE: For these tests, 12-volt power supply "jumper" should be used to supply powerTEMPERATURE LIGHT (400500 cc)
1Connect the indicator light connector to the main wiring harness2Pull the instrument pod wiring with light bar upward and install the light bar into the instrument pod3Secure the instrument pod with existing hardware; then secure the instrument pod wiring to the steering post using cable tieHI BEAM INDICATOR VOLTAGE NOTE: The ignition switch must be in the LIGHTS positionAlso, the dimmer switch must be in the HI position, and the test must be performed on the lower side of the connector
1Connect the jumper positive wire to the power source terminal on the indicator light connector2Connect the jumper ground wire to the temperature terminal on the indicator light connector3The water temperature warning indicator light should illuminateNEUTRAL POSITION LIGHT