2000 Arctic Cat ATV Factory Service Manual, Page 40Get this manual
Switches Each time the ATV is used, switches should be checked for proper operationUse the following list for referenceAIgnition switch engine will startBEmergency stop switch engine will stopCReverse lever switch reverse indicator light illuminatesDHiLo switch headlight beam bright and dimEBrake switches rear brakelight illuminates
3At the adjuster, loosen the "upper" jam nut and thread it to the middle of the adjuster4Shift the lever to the "reverse" position5At the reverse shift arm, attempt to line the cable connector with the engine arm and install the clevis pinclip6If the clevis pinclip cannot be installed, adjust the "lower" jam nut until it can be installed7Tighten the "lower" jam nut and the "upper" jam nut to secure the adjustmentNOTE: At this point the reverse lever should be adjusted correctlyIf the indicator light does not illuminate, troubleshoot the other possible reasonsFig2-86
Adjusting Reverse Shift Lever
0732-414
Indicator LightsGauge
ATV-0091