TGB Blade 250 ATV Quad Service Repair Manual, Page 9Get this manual
1GENERAL INFORMATION The length of bolts and screws for assemblies, cover plates or boxes is different from one another, be sure they are correctly installedIn case of confusion, Insert the bolt into the hole to compare its length with other bolts, if its length out side the hole is the same with other bolts, it is correct boltBolts for the same assembly should have the same length
Remove residues of the old gasket or sealant before reinstallation, grind with grindstone if the contact surface has any damage
The ends of rubber hoses (for fuel, vacuum, or coolant) should be pushed as far as they can go to their connections so that there is enough room below the enlarged ends for tightening the clampsGroove Clamp
Tighten assemblies with different dimension fasteners as follows: Tighten all the fasteners with fingers, then tighten the big ones with special tool first diagonally from inside toward outside, important components should be tightened to times with appropriate increments to avoid warp unless otherwise indicatedBolts and fasteners should be kept clean and dryDo not apply oil to the threads